Installation Instructions

27
Design Guide - Flush Installation
3/4” RAISED DOOR PANEL ROUTING
For 3/4” raised door panel, routing is required. The router depth is 1/4” all the way around the panel back. Additional
panel width reductions are required per the diagrams below. This will create a “picture frame” routing that will slide
onto the attached door trim.
1/4”
11/32”
1/4”
3/4” PANEL SIDE VIEW
(AFTER ROUTING)
Front
TOP DETAIL TOP
CORNER VIEW SHOWING
“PICTURE FRAME” ROUTING
DETAIL BOTTOM
BOTTOM
Back
Front
Back
7/16”
3/4”
1/4”
NOTE: Routed areas should be
finished as they may be visible
when assembled.
3/4” PANEL BOTTOM VIEW
(AFTER ROUTING)
LEFT
SIDE
RIGHT
SIDE
Front
Back
DETAIL
LEFT SIDE
DETAIL RIGHT
SIDE
2-1/16” 2-1/16”
ROUTER DEPTH 1/4” ROUTER DEPTH 1/4”
NOTE: For panels constructed with rails and stiles (5-panel), the minimum width is 3” for rails and 4” for stiles.