Installation Instructions

ManualsBrandsMonogram ManualsFreezersMonogram 36 Inch Wide 21.9 Cu. Ft. All Freezer with Right Hinging Door

SIDE PANELS

Side panels must be

used whenever the

sides of the unit will

be exposed. The 1/4”

side panels will slip

into the side case trim.

Secure the panels to

the unit with stick-on

hook and loop fastener

strips. Order the side

panels from the cabinet

manufacturer.

• Cut a notch in the top

front corner as shown

to allow clearance

for corner keys in the

front side trim.

* Depending on

installation height.

ZUG2 GRILLE PANEL DIMENSIONS

The ZUG2 unified grille panel kit provides for the

installation of a framed or overlay grille panel.

Note: For 3/4” panels , use the same routing

instructions as single installation , page 28.

Assemble the overlay panels in the same manner

as the door panel.

Door panel dimensions for dual installation will be

69-3/4” x 36-7/8”. For 3/4” panels follow the same

routing procedure per instrucitons on page 29.

Framed Panel Dimensions

A (Width) B (Height)

3/4” Routed Panel 74” 10-7/16”

Overlay Panel Dimensions

A (Width) B (Height)

1/4” Backer Panel 69-7/8” 8-7/8”

0.10” Spacer Panel 68-1/2” 7-5/8”

1/2” Smooth Panel 74” 10-7/16”

IMPORTANT NOTE: The maximum weight for the

unified grill is 25 pounds.

Design Guide - Flush Installation

*84"

2-9/16"

24"

*3" to 4"

3/16"

1-7/8"

UNIFIED DOOR PANEL DIMENSIONS

REFRIGERATOR LOCATION

• Do not install the refrigerator where the tempera-

ture will go below 55°F (13°C). It will not run often

enough to maintain proper temperatures.

• Do not install the refrigerator where temperatures will

go above 100°F (37°C). It will not perform properly.

• Do not install the refrigerator in a location exposed to

water (rain, etc.) or direct sunlight.

• Install it on a floor strong enough to support it fully

loaded.

SIDE CLEATS

Wood cleats are required to be installed vertically

down both sides of the cabinet opening to provide

depth stop for the refrigerator when installed into the

opening.

The cleat should be installed per the diagrams

below based on the type of panel being used.

5-1/4”

Finished

Cleat

Case Trim

1/2”

3/4” Panel

DOOR

TOP VIEW

5-3/8”