Installation Instructions

STEP 7 ADJUST DOOR SWING
NOTE: This appliance has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfac-
tory for your installation situation.
• Open the grille to view the top hinge. Note the door
stop pin locations. The pin is factory-installed in the
115° position.
• Close the door. Use Pliers to unscrew the door stop
and reinstall in the 90 degree position. Close the grill.
Installation Instructions - Flush Installation
36
Pin Location
for 90°
Door Swing
Pin Location
as Shipped for
115°
Door Swing
STEP 8 INSTALL GRILLE PANEL
• Raise the access panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
Improper installation can lead to a finger pinch
point hazard between the side door trim and the
cabinets when operating the door, especially with
children. To minimize this risk you must follow
the installation instructions for cabinet
dimensions, trim assembly, and door stop angle.
Door Trim Pinch Point Hazard
WARNING