Installation Instructions

Custom Handles

• Custom handles must be used for flush installation.

The handle must be properly secured to the overlay

panel before sliding the panel into the trim.

• The cabinet manufacturer will supply the custom handle

and hardware.

• Discard the supplied handle.

• Slide assembled door panel into the trim.

• A trim cover kit has been supplied with your refrigerator.

It contains a piece of trim for both left and right door

swing. You will only need to use one piece of trim on

the handle side of your refrigerator in place of the trim

piece you just removed. Place trim against the side of

the refrigerator door, aligned top to bottom. The holes

in the trim should align to the holes in the door. Discard

the other trim piece.

• Secure the new trim cover piece

using the retained screws.

Installation Instructions - Flush Installation

Use Rear Holes

to Secure Trim

Use Front Holes

to Secure Handle

STEP 9 INSTALL OVERLAY PANELS

Install door panels:

• Open door to 90°. Remove the 6 Phillips head screws

from the door handle.

• Remove the handle.

• Remove the 6 screws holding the trim, then lift off the

trim. Retain the screws.

Install 6 Handle

Side Trim Screws

Refrigerator

Door

Custom Tr

Handle Side