Owner's Manual
18
Installation Instructions - Standard Installation
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
• Use a 3/16” bit to drill four evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16” bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4” (1.91 cm)
min. wood brace. The brace spanning the enclosure
must be securely fastened to cabinets on both sides.
• Install four, 1-1/2” drywall screws into the pilot holes.
• Drill screws into adjacent cabinets through side case
trim.
STEP 9 ADJUST DOOR SWING
NOTE: This refrigerator has a 3-position door stop: 90°,
115°, and 130°. When space does not allow the door
to swing open fully to 115°, you may change the door
swing to a 90° opening. A 130° door swing option is
available for standard installation only. Skip this step
if door opening is satisfactory for your installation
situation.
• Open the door to view the bottom hinge. Note the
door stop pin locations. The pin is factory installed in
the 115° position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 130° or 90°
position.
31-49171 Rev. 2