Owner's Manual

Installation Instructions - Standard Installation
STEP 10 INSTALL GRILLE PANEL
To insert the framed or overlay panel into the grille:
• Raise the grille panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
CAUTION
SHARP EDGE HAZARD
The metal panel may be slippery. Grip the metal
panel firmly so the panel does not slip out of the
frame and cause personal injury or damage to the
frame.
ATTENTION
RISQUE DE COUPURE : ATTENTION
AUX ARÊTES VIVES
Le panneau en métal peut bêtre glissant. Tenir fermement
le panneau en métal, de manière à ce que le panneau
ne glisse pas en dehors du cadre en provoquant des
blessures corporelles ou des dommages au cadre.
PRECAUCIÓN
RIESGO DE EXTREMO FILOSO
Es posible que el panel metálico esté resbaladizo. Tome
el panel metálico de manera firme, de modo que no se
deslice fuera del marco y ocasione lesiones personales o
daños sobre el marco.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
Adjust Nut Below
Spring to Accommodate
Panel Weight
Loosen
Side
Trim
Screw
Loosen
Side
Trim
Screw
19
31-49171 Rev. 2