Owner's Manual

STEP 12 CONNECT WATER SUPPLY
WARNING
Connect to potable water supply
only.
AVERTISSEMENT
Raccordez l’appareil à une
alimentation d’eau potable seulement.
ADVERTENCIA
Realice la conexión a un
suministro de agua potable únicamente.
• Locate and bring the tubing to the front of the cabinet.
• Turn the water on to flush debris from the line. Run
about a quart of water through the tubing into a
bucket, then shut off the water.
Copper Tubing:
• Slip a 1/4” nut and ferrule (provided) over both ends
of the copper tubing. Insert the tube into the union
fitting on the unit and tighten the nut to the union.
• Turn on the water to check for leaks.
22
Installation Instructions - Standard Installation
STEP 11A INSTALL OVERLAY PANELS
(Cont.)
• Pull the tape a few inches at a time while pressing the
trim against the door. Press and hold approximately
10 seconds before continuing along the length of the
door.
• Install another bracket at the bottom of the door to
secure the cover trim. Use a stubby Phillips head
screwdriver and the 2 screws provided.
• NOTE: Make sure there are no gaps in the
installation.
• Follow the same procedure on the opposite door.
STEP 11A INSTALL OVERLAY PANELS
(Cont.)
Custom Handles
• If you are using custom handles, the handle must be
properly secured to the overlay panel before sliding
the panel into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Discard the supplied visor handle.
• Reinstall the handle side
door trim, using all 6 supplied
flat-head screws, plus the 6
flat-head screws originally
installed in the handle door
trim.
• Install a supplied bracket onto
the top of the door, using
a Phillips head screwdriver
and the 2 screws provided.
Hand-tighten the screws
into the end caps. Do not
overtighten; damage will
occur.
• Clean the aluminum trim with rubbing alcohol - do
not use alcohols with oil or lanolin that will prevent
adhesion of double-sided tape.
• Slip the aluminum cover trim onto the top bracket to
check the fit. The aluminum cover trim has a slot on
each end which fits the bracket.
• Remove the trim. Peel away a few inches of the
adhesive backing.
IMPORTANT: The tape is very sticky and strong.
Once it adheres to a surface, it cannot be removed
without damaging both surfaces. Do not install the
trim before the final wood panels are in place. Be
sure to align the trim carefully before removing the
paper backing.
• Carefully place the aluminum cover trim onto the top
bracket so that the bracket is inside the cover trim.
Use the top to bottom grooves along the handle side
to align the cover trim accurately. Align the bracket
with the screw holes in the top of the door.
Reinstall all original screws.
Secure top
bracket with
2 screws.
Top Bracket
Top Bracket
Slide aliminum
trim over top
bracket.
Refrigerator
Water Supply
House
Water Supply
31-49171 Rev. 2