Owner's Manual

23
STEP 12 CONNECT WATER SUPPLY
(Cont.)
SmartConnect
™
Tubing:
NOTE: The only Monogram-approved plastic tubing is
supplied in the SmartConnect
™
Refrigerator Tubing kits.
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
SmartConnect
™
Refrigerator Tubing Kits are available
in the following lengths:
2’ (.6 m) WX08X10002
8’ (2.4 m) WX08X10006
15’ (4.6 m) WX08X10015
25’ (7.6 m) WX08X10025
• Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression nut
until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with the toekick installation.
Installation Instructions - Standard Installation
STEP 14 START ICEMAKER
CAUTION
Avoid contact with the moving parts
of the ejector mechanism, or with the heating element
(located on the bottom of the icemaker) that releases
the cubes. Do not place fingers or hands on the
automatic ice making mechanism while the refrigerator
is plugged in.
ATTENTION
Évitez tout contact avec les pièces
mobiles du mécanisme d’éjection ou l’élément chauffant
(situé dans le bas de la machine à glaçons) qui libère
les cubes. Ne placez pas les doigts ou les mains sur le
mécanisme de production de glace automatique lorsque le
réfrigérateur est branché dans la prise électrique.
PRECAUCIÓN
Evite el contacto con las partes en
movimiento del mecanismo expulsor o con el elemento de
calefacción (ubicado en la parte inferior de la máquina de
hielo) que expulsa los cubos. No coloque los dedos ni las
manos en el mecanismo de la máquina de hielo automática
mientras el freezer se encuentre enchufado.
• Slide the power switch to ON.
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the feeler
arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, slide the switch to OFF.
STEP 13 CONNECT POWER, CLOSE
GRILLE PANEL
• Open the grille panel.
• Plug in the power cord (if necessary) by reaching
into the opening next to the water filter. The water
filter guard will need to be removed for access (some
models). Remove the 3 screws holding it in place. If
access is still too tight, remove the 2 screws holding
the water filter bracket and move aside. Plug in the
power cord. Secure the bracket and guard with the
original screws.
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are on.
• The temperature controls are preset at 37°F (3° C) for
the fresh food section and 0°F (-18°C) for the freezer.
• Allow 24 hours to stabilize before making adjustments.
Feeler Arm
Power
Switch
Icemaker
Water Filter
Guard in Front of
Electric Outlet
Access
Bracket
Screws
Screws
31-49171 Rev. 2