Owner's Manual

CUSTOMIZATION BASICS:
These refrigerators are designed to be customized with decorative panels. Field installed custom door and grille
panels are required.
27
Design Guide - Flush Inset Installation
CUSTOM HANDLE DESIGN GUIDE
Custom handles must be used for flush installation. For custom handle installation,
counterbore holes in rear of decorative panels must ensure 1/2” (1.27 cm) material
thickness remains for handle support.
NOTE: The counterbore must not exceed 1” (2.54 cm)in diameter.
Minimum distance from handle side edge to handle center should be 1-1/4” (3.18 cm) as
shown.
1/4”
1/2”
3/4”
1-1/4”1-1/4”
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
SIDE PANELS
Side panels must be used
whenever the sides of
the refrigerator will be
exposed. The 1/4”
(0.63 cm) side panels will
slip into the side case
trim. Secure the panels
to the refrigerator with
stick-on hook and loop
fastener strips. Order
the side panels from the
cabinet manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
* Depending on installation height.
*84"
2-9/16"
24"
*3" to 4"
3/16"
1-7/8"
7/8"
0.85"
1/2"
31-49171 Rev. 2