Owner's Manual
Installation Instructions - Flush Inset Installation
38
STEP 11 INSTALL OVERLAY PANELS
Install door panels:
• Open door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove the supplied visor handle. Retain all screws.
• Remove the 6 screws holding the door trim on the
handle side, then lift off the trim. Retain the screws.
• Slide the overlay panel into the door trim.
• Custom handles must be used with flush inset.
Make sure handles are attached before installing
panels.
Dispenser Models Only:
• IMPORTANT: The dispenser controls protrude
beyond the face of the freezer door. To avoid damage
to the dispenser, the trim at the top of the door should
be removed.
• Remove the screws holding the top trim in place.
• Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim.
• Reinstall the top trim piece with all of the original
screws.
All Models:
• There are two sets of holes in the door trim. Replace
door trim by installing all of the screws in the two sets
of screw holes.
• Follow the same procedures to install the opposite
panel.
• Discard the visor handle.
Visor
Handle
Door
Trim
Refrigerator
Door
Use front and rear
holes to install all of
the original screws
and secure trim
Top Trim
31-49171 Rev. 2