Owner's Manual

DIMENSIONS AND CLEARANCES
THE INSTALLATION SPACE
*The finished cutout width must be:
35-1/2” (90.17 cm)for 36” models
41-1/2” (105.41 cm) for 42” models
47-1/2” (120.65 cm) for 48” models
Water And Electrical Locations
The opening must be prepared with the electrical
and the cold water supply located as shown.
The Cutout Depth Must Be 24” (60.96 cm)
The refrigerator will project forward, slightly beyond
adjacent cabinetry for standard installation.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be located
on the rear wall as shown.
• The water line can enter the opening through the
floor or back wall. The water line should be 1/4” O.D.
copper tubing or SmartConnect
™
kit between the cold
water line and water connection location, long enough
to extend to the front of the refrigerator. Installation of
an easily accessible shut-off valve in the water line is
required.
Design Guide - Stainless Steel Installation
* Shipping height.
The refrigerator
can be adjusted to
fit into a cutout that
is 84-1/2”
(214.63 cm)
in height. Use
leveling legs
and wheels for
a maximum 1”
(2.54 cm) (height
adjustment.
Product Clearances
These refrigerators are
equipped with a 3-position
door stop. The factory-set
115° door swing can be
adjusted to 90° if clearance
to adjacent cabinets or walls
is restricted. Only standard
installation can be adjusted
to 130°.
43
90° Door Swing
115° Door Swing
*Finished Width
6"
5"
Electrical
Area
84-1/2" max
Finished
Opening
75" From Floor
to Bottom
of Electrical
Area
24"
5"
5"
3 1/2"
Water Supply
3 1/2"
36" Models 12"
42" Models 18"
48" Models 20"
Allow minimum clearances for the freezer door
(Dimension A) and fresh food door (Dimension B) for a
full 115° door swing and to allow for pan removal.
For a 90° door swing, allow 4” (10.16 cm) min.
clearance to a wall, for framed and stainless steel
models. Allow 5” (12.7 cm) min. clearance for
professional series models. If the 90° door stop position
is used, pan access is maintained, but pan removal is
restricted.
See the illustrations on pages 41 and 42 to determine
door swing interaction with adjacent cabinets or
countertops.
Models X
36” 20-5/8” (52.39 cm)
42” 26-5/8” (67.63 cm)
48” 28-5/8” (72.71 cm)
*84"
From
Floor
25-3/8" Framed Models
26-1/8" Stainless Steel Models
Depth Including Handles:
27-7/8" Stainless Steel Models
28-7/8" Professional Models
36", 42" or 48"
Frame to Frame
35", 41", or 47"
Case Width
*83-1/2"
at
Rear
*4” Stainless and
Trimmed Models.
5” Pro Series
B
A
23-7/8"
Behind
Frame
C
*Min. Distance
to Wall
X
31-49171 Rev. 2