Owner's Manual

DIMENSIONS AND CLEARANCES
Product Clearances
These refrigerators are
equipped with a 3-position
door stop. The factory-set
115° door swing can be
adjusted to 130°, or to 90°
on panel models or 90° on
stainless steel models if
clearance to adjacent cabinets
or walls is restricted.
Panel Models Only: Allow minimum clearances for
the freezer door (Dimension A) and fresh food door
(Dimension B) for a full 130° door swing and to allow
for pan removal.
For a 90° door swing, allow 4” (10.16 cm) min.
clearance to a wall. If the 90° door stop position is
used, pan access is maintained, but pan removal is
restricted.
See the illustrations on pages 11 and 12 to determine
door swing interaction with adjacent cabinets or
countertops.
THE INSTALLATION SPACE
*The finished cutout width must be:
35-1/2” (90.17 cm) for 36” models
41-1/2” (105.41 cm) for 42” models
47-1/2” (120.65 cm) for 48” models
Water And Electrical Locations
The opening must be prepared with the electrical and
the cold water supply located as shown.
The Cutout Depth Must Be 24” (60.96 cm)
The refrigerator will project forward, slightly beyond
adjacent cabinetry for standard installation.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be located
on the rear wall as shown.
• Water line can enter the opening through the floor
or back wall. Route SmartConnect™ kit or 1/4” O.D.
copper tubing between the cold water line and the
water connection location. The tubing should be
long enough to extend to the front of the refrigerator.
Installation of an easily accessible shut-off valve in
the water line is required.
Design Guide - Standard Installation
7
*Finished Width
6"
5"
Electrical
Area
85" max
Finished
Opening
75" From Floor
to Bottom
of Electrical
Area
24"
5"
5"
3 1/2"
Water Supply
3 1/2"
36" Models 12"
42" Models 18"
48" Models 20"
* Shipping height. The
refrigerator can be
adjusted to fit into a
cutout that is 84-1/2”
(214.63 cm) in
height. Use leveling
legs and wheels
for a maximum 1”
(2.54 cm) height
adjustment.
*84"
From
Floor
25-3/8" Framed Models
Depth Including Handles 26-7/8”
36", 42" or 48"
Frame to Frame
35", 41", or 47"
Case Width
*83-1/2"
at
Rear
B
A
90° Door Swing
130° Door Swing
(Panel Models Only)
Models A B C
36” 13”
(33.02 cm) 15” (38.1 cm) 20-5/8” (52.39 cm)
42” 13” (33.02 cm) 19” (48.26 cm) 26-5/8” (67.63 cm)
48” 15” (38.1 cm) 20” (50.8 cm) 28-5/8” (72.71 cm)
23-7/8"
Behind
Frame
C
*Min. Distance
to Wall
4”
115° Door Swing
B
A
31-49171 Rev. 2