Specifications
monogram.com
37
Advance planning for automatic icemaker
Drainage requirements
A method of drainage must be determined in advance.
605Dia51
3-1/2"
High
7-1/2"
Locate Standpipe in exact
Center of The Cutout
15"
605Dia50
1" Min. Ga
p
22"
Drain
Hose
3-1/2"
22-3/4" With 3/4"
Custom Panel
Side
View
• The ideal installation has a standpipe with a 2" to 1-1/2" PVC
drain reducer installed directly below the outlet of the drain
tube. The standpipe must be accurately located to prevent
interference when sliding the icemaker into the opening.
Maintain 1" gap between standpipe and icemaker drain hose.
• The installation of a 3/4" custom door panel will influence the
floor drain location.
• When a floor drain is not located below the icemaker, order
ZPK1 drain pump kit. This pump must be installed inside the
unit and can pump to a maximum vertical height of 10 feet.
The 10-ft. tubing is supplied with the kit.
• The drain lines must be at least 5/8" inside diameter.
Door swing clearances
The icemaker is factory set for a right-hinge door swing with
the door swinging from left to right. The door swing may be
reversed to a left-hinge swing. No kits required.
• The installation must allow for clearances to adjacent walls
or cabinets. The icemaker is factory set for a 110° door swing.
Custom panel kits
Order ZIP75WW, white or ZIP75BB, black, 3/4" trimless custom
panel kit.
• Order the panel so that
approximately 1/2" of the back
side edge is finished. The back
edge of the panel will be visible
and therefore should be finished.
• Custom handles may be used
with this kit.
• A side filler panel may be
required on the hinge side to
ensure a full door swing.
605Dia52
29-1/2"
14-23/32"
3/4"
Thick
Custom
Panel
605Dia54
110°
5-1/2" Minimum
to Wall
WALL
21-1/2"
15-1/2"
605Dia53
2" Minimum
to Wall
90°
90° door swing110° door swing
• Allow 5-1/2" minimum clearance on the hinge side for a full
110° door swing.
• 2" minimum clearance is required for access to the ice bin
when the door swing is restricted to 90°.
Au tomati c i cem ake rs
ZTBSS1 Tubular handle
Monogram stainless steel tubular handle can be installed on
the 3/4"-thick custom panel.