Specifications
monogram.com
41
Dish washer s
Monogram
®
dishwashers are designed for versatility,
adaptable to virtually any installation.
• These dishwashers may be installed beneath
countertops of stone or other materials that will
not accept screws.
Supplied or custom toekick
• A two-piece toekick is supplied with model ZBD1800GSS.
The toekick is height-adjustable.
• Depending on cabinetry style, a custom toekick can also
be installed to match cabinetry. Care must be taken to assure
door swing clearance above the toekick.
ADA-compliant ZBD1800GSS:
Installation below 34"-high countertops
A reduced-height installation (32-1/2" min.) beneath a 34"
countertop can be accomplished by adjusting the leveling legs
and toekick.
The installation space
The rough cabinet opening must be prepared to the
dimensions shown.
• The dishwasher must be installed so that the drain hose is no
more than 10 feet in length for proper drainage.
• Water and power supply should enter in the shaded area.
• Electrical and water connections are at the right front of the
dishwasher. The hot water line should extend forward 30" to
40" from the rear wall. The electrical must extend forward at
least 24" to reach the junction box.
• To prevent siphoning, an air gap must be used when the waste
tee or disposer connection is less than 18" above the floor.
Advance planning for dishwashers
Electrical requirements
The dishwasher must be supplied with 120V, 60Hz, and
connected to an individual properly grounded branch circuit
protected by a 15- or 20-amp circuit breaker or time-delay fuse.
Monogram 18" dishwashers
cutout dimensions and clearances
Monogram 24" dishwashers
cutout dimensions and clearances
Cabinets
Square
and
Plumb
Floor MUST
be Even with
Room Floor
This Wall Area
must be Free of
Pipes or wires
34-1/2" Min.
Underside of
Countertop
to Floor
24"
Min.
24" Min.
5" 5"
4"
4"
6"
24"
*24"
34"
Adjustable
to 35"
* Dishwasher models ZBD6890
and ZBD0700 require a 3/4" thick
custom panel and will be 24-3/4"
deep. (not including handle)
ZBD0700Nll and ZBD6890Nll
Fully integrated models with hidden controls.
Require a 3/4" thick custom panel and a custom handle.
ZBD0710NSS, ZBD6800NBB, ZBD6800NWW, ZBD6880NSS
dishwashers. These models have a fully wrapped black, white
or stainless steel door.
Cabinets
Square
and
Plumb
Floor MUST
be Even with
Room Floor.
34" to 35"
Underside of
Countertop
to Floor
24"
Min.
17-5/8" Min.
18" Max.
17-1/2"
22-1/2" Max.
32-1/2"
Adjustable
to 35"