Specifications

6
Advance planning for built-in side-by-side refrigerators
Side-by-side refrigerators are available in 36", 42" and 48" widths. Design and installation considerations are the
same for all model widths.
The installation space
*Finished Width
6"
5"
Electrical
Area
84-1/2" max
83-1/2" min
Finished
Opening
75" From Floor
to Bottom
of Electrical
Area
24"
5"
5"
3-1/2"
Water Supply
3-1/2"
36" Models 12"
42" Models 18"
48" Models 20"
696Dia15
Space is the first consideration when planning the installation.
* The finished cutout width must be:
35-1/2" min. for 36" wide models
41-1/2" min. for 42" wide models
47-1/2" min. for 48" wide models
The cutout depth must be 24"
The refrigerator will project forward, slightly beyond adjacent
cabinetry, depending on your installation.
The cutout depth beneath a soffit
When installed beneath a soffit, the soffit cannot exceed the
24" installation depth shown. The top case trim overlaps the
bottom of the soffit.
Electrical
A 115V, 60Hz., 15 or 20 amp power supply is required. An
individual properly grounded branch circuit or circuit breaker
is recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall. Electrical
must be located on rear wall as shown.
The serial plate is located above the freezer compartment and
behind the grille panel.
Note: GFI (ground fault interrupter) is not recommended.
Water line
All models are equipped with an automatic icemaker. The
water line can enter the opening through the floor or back
wall. Route GE SmartConnect
™
kit or 1/4" O.D. copper tubing
between the cold water line and the water connection
location. The tubing should be long enough to extend to the
front of the refrigerator. The installation of an easily accessible
shut-off valve in the water line is required.
Product dimensions
* Shipping height. The refrigerator can be adjusted to fit into
a cutout that is 83-1/2" min. to 84-1/2" max. height. The top
case trim at the front is 1/2" higher and will overlap upper
cabinetry or soffit. Use leveling legs and wheels for
a maximum 1" height adjustment.
429Dia8
*84" From
Floor to
Top Frame
36", 42", or 48"
Frame to Frame
35", 41", or 47"
Case Width
Case Depth:
25-3/8" Framed Models
25-3/4" Stainless Steel Models
Depth Including Handles:
26-7/8" Framed Models
27-3/4" Stainless Steel Models
28-11/16" Professional Models
*83-1/2"
at
Rear
Door swing clearances
The installation must allow for clearances to adjacent walls or
cabinets. These refrigerators are equipped with a 2-position
door stop. The factory-set 130° door swing can be adjusted to
90° if clearance to adjacent cabinets or walls is restricted. Order
WX14X99 door stop for precise settings between 90° and 130°.
605Dia4
B
130° Door Swing
A
605Dia5
23-7/8"
Behind
Frame
C
90° Door Swing
4" Min. to Wall
5" Min. for Professional Models
Observe all minimum clearances shown above for a 130° or 90°
door swing. A 90° door swing allows pan access, but removal is
restricted.
• See door swing illustrations to determine interaction with
adjacent cabinets or countertops.
Models A B C
36" 13" 15" 20-5/8"
42" 13" 19" 26-5/8"
48" 15" 20" 28-5/8"