Manual

9
STEP 3 Remote AC Control Hookups
NOTE:
This feature allows you to turn on/off your PowerCenter via your A/V receiver or preamplifier.You can’t turn off
the PowerCenter using the front panel OFF button when the unit is operating in the REMOTE mode.
A) Plug the Remote AC Control Cord’s (included) female end into back of your PowerCenter (see diagram below).
B) Switch the NORMAL/REMOTE switch (located on the back of the PowerCenter) to REMOTE.
C) Plug the Remote AC Control Cord’s 2-prong male end into a switched AC power outlet on a receiver
or preamplifier.When you turn on your receiver or preamplifier the PowerCenter’s outlets programmed
as “switched on” will be turned on immediately. However, the PowerCenter’s outlets programmed
as ”switched on after delay” will be turned on after a delay set by the DELAY TIME switch.
GROUND
IN OUT
IN OUT
IN OUT
CABLE TV
SATELLITE
ANTENNA
PHONE
OUT 1IN
OUT 2
BREAKER 15A
PRESS TO RESET
1800W MAX TOTAL
21 3 4 5
DC IN
9~12V 300MA
REMOTE
AC IN
110V
REMOTE
NORMAL
DC OUT 9~12V 300MA
NO DELAY
DELAY
OUTLET PROGRAMMING SWITCHES
DELAY TIME
SWITCH
LONG
(20 seconds)
SHORT
(6 seconds)
TRIGGER OUT
SWITCH
UNSWITCHED SWITCHED
DELAY
NO DELAY
1
2
3
5
4