Manual

25
TROUBLESHOOTING (continued)
Possible Cause #3
The PowerCenter’s power cord is plugged into an outlet on the back of one of your components and the component
is not turned On.
Possible Solution
• Turn on the component.
NOTE: For the best possible performance, plug the PowerCenter into a wall outlet,
not an outlet on another component.
Possible Cause #4
The PowerCenter is defective.
Possible Solution
• Please see page 35 for warranty information.
PROBLEM – PowerCenter is not providing power to the components.
Possible Cause #1
The component is plugged into an outlet programmed as “switched on” or “switched on after delay”
and the PowerCenter has not been turned on.
Possible Solutions
• Press the ON button on the PowerCenter. The components plugged into the PowerCenter”s
outlets programmed as ”switched on“ should be turned on immediately.
• Press the ON button on the PowerCenter and wait for a few seconds for the components plugged
into the PowerCenter”s outlets programmed as ”switched on after delay“ to be turned on.
• Or, plug the component into an outlet programmed as “unswitched”.