Installation Guide
Montana Woodworks, Inc.
Assembly Instructions for Log Daybed
Thank you very much for purchasing our heirloom quality log daybed. Should you have any
questions or need to contact sales or support, please do not hesitate to contact our corporate
offices at 888.889.3728 or via E-Mail at: cs@montanawoodworks.com
Before beginning assembly please take a few moments to read the instructions carefully,
understanding each step. Likewise please also ensure that the hardware package contains the
items as described here.
Tools Needed: 9/16” Wrench or Socket, Hammer
Parts List: (1) Log Back Support, (2) Log Arm Supports, (1) Top Spring,
Hardware List: (4) 3” Lag Bolts & Washers, (8) Lag Shields, (8) 2 ½ “ Lag Bolts and Washers
Step 1. Bolt Log Back support to Log Arm supports by inserting back supports into pre-drilled
holes in arm supports. Note; it may be necessary to cut the black banding around Log Back
Support at this time. If Back Supports fits easily into Arm Support holes, leave banding intact
until step 5.
Step 2. Secure Back Support/Arm Support assembly with the (4) 3” lag screws. DO NOT FULLY
TIGHTEN THESE BOLTS UNTIL AFTER THE TOP SPRING HAS BEEN SECURED.
Step 3. Attach the Top Spring into the pre-drilled holes on arm supports. Insert lag shields into
pre-drilled holes (tap them in with a hammer) and line up frame. Secure with (8) 2 ½ “ lag bolts
and washers.
Step 4. FULLY TIGHTEN ALL BOLTS/FASTENERS AT THIS TIME.
Step 5. Cut black banding around Back Support at this time if not done earlier.
PROUDLY MADE IN THE U.S.A.
Pine requires a good sealant. We recommend two coats of varnish being applied per manufacturer’s directions. The item
may be stained prior to the application of the varnish.