Installation manual

4/20/2012

#/-/3>/:5/+:73710=7-<38768<8:

After the fan is powered (DC motor), the receiver will start sourcing the frequency in the first 30 sec-

onds; during the time, any instruction from the transmitter (pressing any button) will be recognized and

memorized as the ID frequency of the using transmitter; frequencies from the other transmitters won’t

be identified as the instruction to operate your fan. When the power is off and on again, if the receiver

does not receive the frequency from the transmitter in 30 seconds, receiver will automatically use last

frequency set before the power off.

$/<<371=9<2/!;?3<-28558?,/58?;</9;

1.Cut off power supply (turn off the power switch) to the fan before setting up and matching between

the fan and the transmitter.

2.Then set/change the DIP switch on the transmitter wanted to work with the fan.

3.Then re-connect the power supply (turn on) the fan again. 0<2/98?/:3;87+5:/+.@@8=6=;<

<=:7<2/98?/:80003:;<<=:7800<2/98?/:;?3<-2+7.<2/7<=:7<2/98?/:,+-408:5/+:7

0=7-<387;/<<371

4.Push any key on transmitter within 30 second (//99=;371<2/4/@08:+<5/+;<;/-87.;), the

fan will match and set up with the transmitter.

5.Repeat the above steps for the other set of fans and transmitters in the house.

$9/-3+578</

1.If there is a power failure, and you have more than one fan inside the house, do not push the trans-

mitter within 60 seconds, otherwise the transmitter signal will be picked up by all fans and the fans can-

not be controlled separately.

2.The fan can remember the running setting before power failure or cut off.

3.If the new fan runs after connected to power, it may be due to the fan remembering the previous

running setting in the factory during the QC process, push “stop” key on transmitter twice to stop.

9/:+<3877;<+55+<387

1. Remove the battery cover and the battery from the transmitter, you will see 4 dipswitches with on/off

printing, adjust the dipswitches with your own choice (different combinations).

2. Power your fan, use the transmitter to send the signal to the receiver by pressing any button on the

transmitter, the receiver will memorize the frequency from the transmitter as the ID signal from now.

3. Refer to page 8 for remote control transmitter features.

%39;08:/7.=;/:;

1. Once the power is off from last using and you want to restart your fan, in case there are two fans or

more in your house with the same transmitter and receiver set, REMEMBER to wait for 60 seconds

before using the transmitter, otherwise it will cause a transmitter to control both fans in the same time.

2. Receiver has the memory function, fan will automatically return to the previous setting before power

off.

3. If your fan is operated automatically after installation, it is because your fan still memorize the previ-

ous setting at factory, just simply press the “stop” button on the transmitter twice to stop your fan.

4. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it

turns. It is a normal performance of this fan and it will take for few seconds to run this operation.

5. If fan or light isn't working, reset the power ( turn power off and then turn it back ) and redo the

learn function.