Installation manual

4/20/2012

FORWARD/REVERSE Depress reverse button and allow a few seconds

for remote to change rotation direction with fan running. The fan will come to

a complete stop and then run in the opposite direction. This process may take

20-30 seconds.

FAN OFF SETTING

(Turns fan off only)

FAN REVERSE (Press

once to change direction

of the fan)with fan run-

ning.

LIGHT ON/OFF SET-

TING AND DIMMER

(Press and hold to

dim light infinitively)

Fan speed control

FAN SPEED Depress “#1 bar is for highest speed.The #7 bar is for the lowest

speed.

LIGHT DIMMER To turn light on, press light dimmer once quickly. To turn

offpress once quickly while light is on. To dim light hold down button “light

dimmer”. The light will cycle from bright to dim to bright until button is

released. Light willmaintain last setting if turned off. You can see the percentage

on the display screen.

NOTE: If you have more than 1

fan with a remote, you will have

to change the DIP switch settings

located above the battery of the

remote. There are no DIP switch-

es on the fan. Only change the

remote DIP switches.

When the low battery

sign is shown on the

LCD display, replace a

new battery.

LIGHT DELAY

Pressing the light delay but-

ton activates the light delay

function. The light will auto-

matically shut off after 1

minute.

Memory for fan speed.

Press "M", fan will run

at the speed as last

setting if it was turned

off by remote con-

troller