Owner’s Manual Ceiling Fan Installation Instructions Total fan weight with light kit included For 5NCR56 Series Fans READ AND SAVE THESE INSTRUCTIONS Quality Ceiling fans
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1996), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3.
8 7 Align hole in downrod with hole in yoke and install cross pin. Install cotter pin into cross pin. 10 11 Push yoke cover down. 13 Install upper glass to top of fan. Install 4 Max. 25 watt candelabra base bulbs into the sockets on top of the fan as shown. 9 Tighten the 2 set screws on the yoke once the downrod is in place. Then tighten locking nut. 12 Attach blade brackets to blades using the blade bracket screws and washers provided.
19 20 21 Remote Transmitter Dip swtiches Remote Receiver Dip switches Raise fan with downrod assembled to the ceiling bracket and hang fan assembly. Be sure to rotate the downrod ball so that the notch in the bracket engages the slot in the ball and the bracket slides shut. 22 With the bracket shut (see # 23) start the two screws do not tighten at this time. 23 Set dip switches on the Remote Transmitter and Remote Receiver to the same settings.
31 33 32 Replace inspection plate from light kit pan. Install the 2x50 watt halogen bulbs. Do not touch bulb glass surface as oily residue from skin can cause the bulb to explode. 36 35 34 Find tabs on light kit pan. Align the indentions on glass with tabs lift glass and twist till glass is secure. AC 120V input white black white black ground black black Warning! Hook up In Series Only. Do not connect to hot and common wire of electric circuit or switch will be damaged.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
