Owner’s Manual Ceiling Fan Installation Instructions Total fan weight For 5ROR Series Fans BLADES NOT INCLUDED READ AND SAVE THESE INSTRUCTIONS Quality Ceiling fans
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3.
7 8 9 Lift mounting neck to mounting Plate and align screws. Secure mounting neck to the mounting plate with four screws to become a complete mounting bracket. Remove keeper from pin and then pin from yoke and save. 10 11 12 Loosen 2 set screws with lock nuts in yoke till you can not feel them on inside of yoke. Check the motor for plastic shipping stabilizers and remove if present. 13 Loosen 3 screws with key hole slots and remove the 1 screw without key slot. Save screw removed.
19 20 21 Place upper housing over downrod. Place canopy over downrod. Install ball on downrod, replace cross pin and tighen screw securely. 22 23 24 Remote Transmitter Dip swtiches Remote Receiver Dip switches Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball.
31 32 33 Install blade and blade holder assembly to fan motor using the preinstalled screws,washers and motor pads. Repeat this process 4 more times until all blades are installed to the fan. Loosen 4 screws with key hole slots and remove 1 screw without key slot. Save screw removed. Place blade holder cover with key hole slots over 4 screws and twist direction of arrow. Replace screw removed and tighten all screws securely.
43 44 45 Fan speed control buttons Fan on / off Install wall control unit to outlet box using machine screws provided. Attach front cover to wall control with screws provided. Light dimmer for up and down lights Fan reverse button To control fan speed select from High, Medium or low speed buttons. To turn the fan off press the Fan on / off button. To dim upper lights press and hold U/L botton. To dim Lower lights press and hold D/L button.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
