Owner’s Manual Ceiling Fan Installation Instructions Total fan weight with lights For 5VYR56XXD Series Fans READ AND SAVE THESE INSTRUCTIONS Quality Ceiling fans
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3.
7 8 9 Lift mounting neck to mounting Plate and align screws. Secure mounting neck to the mounting plate with four screws to become a complete mounting bracket. Loosen 3 thumb screws with key hole slots. 10 11 12 Place the key hole slots over the 3 screws on fan body and twist upper cover in direction of arrow. Tighten all 3 thumb screws securely. 13 14 15 Install canopy and yoke cover over downrod and then thread lead wires and safety cable through as shown.
19 Safety cable installation 20 21 Safety Cable Lag Screw safety cable washer 3” lag screw lock washer Fan and light kit combinations over 70 lbs, in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.
31 32 Install blade and blade holder assembly to fan motor using the preinstalled screws,washers and motor pads. Repeat this process 4 more times until all blades are installed to the fan. If not using light kit go to step 33. If using light kit go to step 36. Loosen 2 screws and remove 1 screw. 34 35 36 Place over the 2 screws and twist in direction of arrow to hold in place. Replace screw removed and tighen all 3 screws securely.
43 Remove cover by snaping off from top or bottom. Install 12V battery into wall remote. Duracell MN21 / Eveready A23 / GP 23A all 12V. 44 45 Attach cover of remote by placing over buttons and snaping into place. Install wall control unit to outlet box using machine screws provided. 46 47 Fan speed control buttons Fan on / off Attach front cover to wall control with screws provided.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.