Owner’s Guide and Installation Manual 5SLR52XXD-V1 Series Fan UL Model No. : 5SLR52XXXD-V1 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: MODEL NUMBER: RETAILER ADDRESS: To register your fixture, please visit our website www.montecarlofans.com 10.1 kgs 22.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
1 2 3 Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. Before installing this fan make sure the outlet box is properly installed to the house structure.
10 11 12 Align the hole in the downrod with the hole in the yoke. Insert th pin through the yoke and downrod until the point appears on the other side. Install the keeper to pin. Tighten the 2 set screws on the yoke once the downrod is in place. 13 14 15 Safety cable installation Safety Cable Lag Screw safety cable washer 3” lag screw Pull down yoke cover. 16 lock washer Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight.
19 21 20 white black Make wiring connections as indicated above. White from fan to white from remote marked N. Blue from fan to blue from remote marked light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House. Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut.
28 29 Remove battery cover. Install 12V battery into wall remote. Duracell MN21 / Eveready A23 / GP 23A all 12V.Attach cover of remote by placing over buttons and snap the battery cover in place. Place face plate over battery compartment and buttons. Place remote over 2 pins on front cover. Attach cover of remote by placing over 4 pins and snapping into place. HAND HELD INSTALL 30 WALL MOUNT INSTALL Install wall control unit to outlet box using machine screws provided.
Remote Control Transmitter Features LED LIGHT MEDIUM SPEED FAN REVERSE (Press once to change direction of the fan) Fan must be running to reverse. HIGH SPEED LOW SPEED LIGHT ON/OFF SETTING AND DIMMER (Press and hold to dim light infinitely) FAN OFF SETTING (Turns fan off only) FAN SPEED Depress “1 dot” for low speed, “2 dots” for medium or “3 dots” for high. To turn fan off press square”. LIGHT DIMMER: To turn light on, press light dimmer once quickly.
TROUBLE SHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
Feb.2012 New format Jun.2013 Update for CUL regulation Aug.2017 LED lamp Oct.
