Installation Sheet

SAFETY INFORMATION AND GENERAL GUIDE

READ AND SAVE THESE INSTRUCTIONS

• Please read and understand this entire manual before attempting to assemble, install or operate

the product.

• Make sure that all electrical connections comply with local codes, ordinances, the National

Electrical Code and ANSI/NFPA 70-1999. Hire a qualified electrician or consult a do-it-yourself

wiring handbook if you are unfamiliar with installing electrical wiring.

• Warning: Before proceeding, be sure to shut off electricity at main switch or circuit breaker in

order to avoid electrical shock.

ESSWC-7-WH WALL TRANSMITTER

INSTALLATION AND OPERATION INSTRUCTION

Note

: Fan installation must be complete including assembly of blades before testing wall control

unit.

Note: Refer to your Ceiling fan instruction manual for Safety and installation instruction.

This wall controller is to be used for the control of ceiling fan and fan light only, and in an

AC 120V 60HZ power supply only.

Warning: Do not exceed maximum rating of the wall transmitter. Install the wall transmitter

away from excess heat or humidity

Customer Service

800-969-3347

Customer Service Center

7400 Linder Ave.

Skokie, IL 60077

www.montecarlofans.com

PAGE 1
ESSWC-7-WH WALL TRANSMITTER INSTALLATION AND OPERATION INSTRUCTION SAFETY INFORMATION AND GENERAL GUIDE READ AND SAVE THESE INSTRUCTIONS • Please read and understand this entire manual before attempting to assemble, install or operate the product. • Make sure that all electrical connections comply with local codes, ordinances, the National Electrical Code and ANSI/NFPA 70-1999. Hire a qualified electrician or consult a do-it-yourself wiring handbook if you are unfamiliar with installing electrical wiring.
PAGE 2
Black AC IN L Black To Hot White AC IN N Black from fan (Receiver) Note: Before installing the wall transmitter, place it in OFF position by pushing ON/OFF switch to the OFF. Black To Fan Make series-wound connection for the wall transmitter with HOT wire from house.
PAGE 3
WALL TRANSMITTER OPERATION The buttons on the wall transmitter control the fan speed and light as follows. (Fig. 4) LED Indicator Press the button to get desired fan speed, Low to High. UP Speed Press the button to get desired fan speed, High to Low. Press the OFF button to turn fan off. Down Speed Press this forward/reverse button to get desired airflow direction. Fan must be running to reverse. It will take about 25 seconds for fan to slow down and change rotation direction.
PAGE 4
Jun.2015 Feb.