Communications Document

37Morningstar Product Connectivity Manual

5.5 Setup Wizards

MSView

providesseveralSetupWizardsdesignedtomakeconguringandcustomizingyour

Morningstar product quick and simple. Currently six (6) wizards are available: Relay Driver, Sun-

Saver Duo Setup, SunSaver MPPT Setup, TriStar DIP Switch, TriStar Setup, and TriStar MPPT

Setup. These are accessible through the Tools menu.

5.5.1 Relay Driver Wizard

Each of the four channels on the Relay Driver is assigned a function which will switch the chan-

nelson/offdependinguponspeciedcriteria.Thiswizardwillassistyouindeningthesefunc-

tions and customizing the RD to your needs.

The following functions are available:

Disabled - disables the channel and allows for input voltages/signals to be read on that •

channel.

Threshold - switches a channel on/off according to a low threshold and a high threshold •

denedbytheuser.

Alarm/Fault - monitors faults and alarms from a Morningstar Device over the MeterBus •

connectionandactivatesthechannelwhenspeciedalarm(s)orfault(s)occur.(Each

channel can only monitor alarms/faults from one device.)

GenStart-congureuptothree(3)channelstocontrolagenerator.Refertothegenerator•

manualforrequiredsignals,timing,andotherspecications.

MeterBus Slave - allows a Morningstar device to control a Relay Driver channel directly.•

MODBUS Slave - allows direct control over a channel via serial connection with a PC or •

other MODBUS compatible device.

For more information on the step by step use of this wizard, please refer to the Help Topics in

MSView

5.5.2 SunSaver Duo Setup Wizard

Custom settings can be programmed to the SunSaver Duo via MSView

. This wizard allows for

stepbystepspecicationofthesesettings.AfterselectingtheSSDSetupWizard,pleaseread

the warning and select OK if you accept the terms.

NOTE: DIP switch 4 must be ON to use custom setpoints.

Disconnect power from the controller before changing any

DIP switches; failure to do so will cause a fault.

A custom setpoints table is displayed along with several buttons allowing to read/write the set-