Instructon Booklet

9
4
.
If the filter (15) is not washed as instructed in
‘
Maintenance - filter’, it is recommended that the
f
ilter is brushed or tapped clean before refitting
on each empty of the dust canister.
5
.
Replace the filter into the dust canister (14), then
replace the dust canister back onto the handheld
v
acuum cleaner.
6
.
R
eplace the handheld vacuum cleaner
(
13)
b
ack
i
nto the main vacuum cleaner body
(
7)
i
f upright
cleaning.
WARNING: Always remove the handheld vacuum
cleaner from the main vacuum cleaner body and
the charger from the mains supply before
undertaking any maintenance or cleaning
procedures.
Your cleaner is manufactured to withstand normal
day-to-day use, but an occasional wipe over with
a damp cloth will help maintain its good looks.
Take care not to get the electrical connections
wet.
Abrasive cleaners should not be used.
The guarantee may be invalidated if the motor is
damaged due to: using the appliance without
the filters installed; not cleaning the filters; or
not replacing a damaged filter.
Cleaning the dust canister filters
To maintain suction, the dust canister filters
must be cleaned each time the dust canister
(14) is emptied.
1. Follow steps 1-4 of ‘Emptying the dust canister’.
2. Pull the pleated filter (15c) out from the filter
assembly (15). There is also a main foam filter
(15b) between the cyclone cone (15a) and the
pleated filter - this must also be removed. Also,
open the lid to the cyclone cone and clean the
cyclone.
3
.
Every month, wash the foam filter (15b) (certain
m
odels only) and the pleated filter
(
15c)
i
n
l
uke-warm water and thoroughly air dry before
re-fitting.
IMPORTANT: Do not wash the filter(s) with hot
water or detergents.
IMPORTANT: Do not use heated appliances to
d
ry the filter(s).
4
.
Replace the filter(s) into the dust canister (14)
t
hen replace the dust canister back onto the
h
andheld vacuum cleaner
(
13)
.
5. Replace the handheld vacuum cleaner back into
the main vacuum cleaner body
(7) if upright
cleaning.
The motor protection filter
Never use the product without the motor
protection filter (15d) fitted. This filter should only
require cleaning if the product has been used
incorrectly without the main foam filter (15b) and
the pleated filter (15c) installed. If this happens,
remove the motor protection filter (15d) and clean
it in luke-warm water and thoroughly air dry
before re-fitting.
IMPORTANT: Do not wash the filter with hot
water or detergents.
IMPORTANT: Do not use heated appliances to
dry the filter.
Maintenance - filters
Maintenance
15 a 15 b 15 c
15 d
VC732007MUK Rev1.qxp_Instruction Book 25/08/2015 15:13 Page 9