Hot Beverage Maker User Manual

4
BEFORE FIRST USE
Before using the appliance for
the first time, fill with water, boil
and pour away.
OPERATING THE
APPLIANCE
1 Wherever possible fill through
the spout, as this helps to free
the filter from limescale build-
up.
• The integrated water level
indicators allow you to easily
see the amount of water in the
kettle.
• Ensure that you put the
minimum requirement of water
in the kettle, 1 cup 25cls.
• Boil only as much water as you
need as this saves electricity.
2 Place the appliance on the base
unit, ensuring the appliance
locates on to the 360˚
connector.
• The 360˚ connector allows the
appliance to be located at any
position. - ideal for left and right
handed users and convenient
positioning on worktop.
3 Plug in and switch on at the wall
socket.
4 Switch the appliance on.
5 When the water boils the
appliance will switch off
automatically.
• If you are using the appliance
for the first time, pour away the
boiled water and refill.
6 Lift the appliance from the base
unit by the handle ensuring you
hold the appliance level.
• To re-boil, switch to ON again. If
the appliance has just switched
off wait a minute or so before
switching it back on again.
• If you do not put in enough
water, or switch on the
appliance when it is empty, the
safety cut-out will switch off the
power automatically. If this
happens, refill and wait a few
minutes for the element to cool,
then use as normal.
Filter removal
1 Open the lid.
2 Lift the filter upwards from its
location using the tab provided.
3 To refit the filter, slot it into the
side wall guides and press
down firmly. Ensure the filter is
correctly located into the central
guide.
WARNING: Make sure
that the lid is put in
correctly otherwise it
will not close.
UK Helpline 0870 060 2611 Replacement Parts 0870 167 6642 Ireland Helpline 1800 409119
43068 rev2 5/6/06 14:51 Page 6