Specifications

•
Undo and remove the six screws and
collect the belleville springs.
•
Remove the clutch disc.
See also
Removing the gearbox
Checking the clutch actuator
If the clutch is replaced, measure the length of the
clutch control rod in order to use the correct rod.
Measure as follows:
•
Fit the new clutch on the crankshaft.
•
Fit the clutch control bowl in the gear-
box.
•
Fit the gearbox on the engine block.
•
Fit the tool in the gearbox to determine
the clutch control rod length.
•
Measure rod protrusion using a depth
gauge (see picture).
•
According to the value found, select
the correct rod based on the following
table:
Specific tooling
GRISO 8V - 1200 Engine
ENG - 123
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten