Specifications

•
Partially fit the service shaft closing
cap.
•
To screw the cap until it stops, use two
M6 flanged screws larger than the orig-
inal screws.
•
Tighten the two M6 flanged screws op-
erating in stages until the cap stops
against the crankcase.
•
Undo and remove the two M6 flanged
screws.
•
Tighten the cap with the two original
TBEI screws.
Installing sliders
•
Fit the crankshaft and the service shaft
on the crankcase.
•
Fit the fixed chain sliders and tighten
the fixing screws.
•
Tighten the chain caps with O-rings.
•
The operations related to the movable
chain sliders are described in the cyl-
inder fitting section.
See also
Installing the crankshaft
Installing the service shaft
Engine GRISO 8V - 1200
ENG - 140
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten