Specifications

•
Place the flywheel-side flange on the
crankshaft and check if the dowel pin
with the O-ring is correctly placed.
•
When fitting the flange on the crank-
case, make sure that the three dowel
pins match the seats on the crankcase.
•
Apply Teflon tape on the two lower fix-
ing screws at the back in order to pre-
vent oil leaks.
•
Screw the eight flange screws on the
flywheel side proceeding diagonally.
•
Remove the sealing ring centring tool from the crankshaft.
Specific tooling
12.91.20.00 Tool to fit the flywheel-side flange together with sealing ring on the crankshaft
•
To avoid that the shim washer inside
the crankcase moves out of its seat, fit
the two gears and the nut on the crank-
shaft on the generator side.
GRISO 8V - 1200 Engine
ENG - 161
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten