Specifications

Iso screen page
ISO
This display shows general data regarding the
control unit, for example software type, mapping,
control unit programming date
ISO DISPLAY
Specification Desc./Quantity
Mapping -
Engine parameter reading screen page
ENGINE PARAMETER READING
This display shows the parameters measured by
the several sensors (engine revs, engine temper-
ature, etc.) or values set by the control unit (injec-
tion time, ignition advance, etc.)
ENGINE PARAMETER READING SCREEN PAGE
Specification
Desc./Quantity
Engine rpm Engine revolutions per minute: the minimum value is set by the
control unit cannot be adjusted
Injection time - ms
Ignition advance - °
Air temperature °C
Temperature of the air taken in by the engine, measured by the
sensor in the filter casing. This is not the temperature indicated
by the instrument panel
Engine temperature °C
Battery voltage V
Throttle Value corresponding to the throttle when closed (approximate
value between 4.5 and 4.9°) (left throttle supported by the end
of stroke screw). If a different value is read, it is necessary to
activate the parameter "Throttle positioner autodetection" and
obtain this value.
Atmospheric pressure 1015 mPa (approximate values)
The sensor is inside the instrument panel
Lambda probe 100 - 900 mV (approximate values)
Signal when energised that the control unit receives from the
lambda probe: inversely proportional to the presence of oxygen
Lambda integrator When the control unit uses the lambda probe signal (see the
'Lambda' parameter on the 'Device status' display) this value
should be close to 0%
Vehicle speed - km/h
Power supply GRISO 8V - 1200
P SUPP - 182
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten