Specifications

Collect the ring (13).
Remove the support unit (8).
TROUBLESHOOTING
Possible Cause
Operation
1. Fitting error of the radial seal or seal damaged 2. Sliding
surface of the wheel axle seal spoiled or damaged
1. Replace the sealing ring and fit it correctly with the suitable
tool
2. Replace the wheel axle
1. Casing not sealed 2. Closing screws of the casing shells not
tightened to the prescribed torque.
1. Open the casing shells, clean the surfaces, seal it and reas-
semble the casing
2. Tighten the closing screws to the correct torque
1. Dirt between sealing ring and casing 2. Worn sealing ring
fitted 3. Plug not tightened to the prescribed torque
1. Clean and tighten to the correct torque
2. Replace the sealing ring
3. Tighten the plug to the correct torque
1. Damaged cap 2. Retaining clamps or closing cover slacken
3. Fitting error of the radial seal or seal damaged 4. Sliding
surface of the wheel spacer seal spoiled or damaged
1. Replace the cap
2. Screw the clamp with suitable pliers
3. Replace the sealing ring and fit it correctly with the suitable
tool
4. Replace the spacer
1. Cap damaged 2. Internal retaining clamp or external closing
clamp loose
1. Replace the cap
2. Screw the internal or external clamp with suitable pliers
1. Bevel gear pair fitting error 2. Bevel gear pair toothing spoiled
or damaged
1. Replace the bevel gear pair
1. Ball bearings on the wheel axle damaged 1. Replace the wheel bearings
GRISO 8V - 1200 Chassis
CHAS - 233
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten