Specifications

•
Undo and remove the rear attachment
screw fixing the exhaust to the chassis;
collect the locking nut, the spacer and
the washer.
DURING THIS OPERATION SUPPORT THE EXHAUST SO
THAT IT DOES NOT FALL.
Locking torques (N*m)
Silencer to chassis connecting pipe retainer 25
Nm
•
Remove the exhaust end.
Removing the manifold - tail pipe
•
Remove the exhaust end and the ex-
haust manifolds.
•
Remove the starter motor protection in
order to disconnect the lambda probe
connector.
•
Unscrew and remove the nut and re-
move the fixing screw.
•
Remove the manifold - exhaust end
coupling together with the lambda
probe.
See also
Removing the exhaust manifold
Removing the tail pipe
Removing the exhaust manifold
The engine and the exhaust system components get very hot and remain in this condition for a certain
time interval after the engine has been shut off. Before handling these components, make sure that you
are wearing insulating gloves or wait until the engine and the exhaust system have cooled down.
GRISO 8V - 1200 Chassis
CHAS - 237
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten