Specifications

•
sensor: on swingarm, right side, near
the rear brake calliper
•
connector: under the saddle, next to
the right fairing
Pin-out:
•
PINS 1-3 Voltage: approx. 12 V
•
PINS 2-3 Voltage: variable 0.4V-12V
(by turning the rear wheel)
PIN:
1. Supply voltage (green)
2. Output signal (grey/white)
3. Ground (blue/orange)
AXONE: ELECTRICAL ERRORS
Speed sensor - invalid signal.
Error cause
•
Error signal if a speed below the default value set by the manufacturer for the running vehicle
is detected. Possibly shorted to ground, battery or speed sensor circuit open: lack of supply
from the control unit also possible.
Troubleshooting
CARRY OUT THE CASCADE OPERATIONS UNTIL THE FAILURE IS FOUND
•
Check correct position of the sensor in its fitting.
•
Check voltage between PINS 1-3 of the sensor. In case of null voltage, check continuity
between PIN 1 of the sensor and PIN 17 of the ECU BLUE connector.
•
Check PIN 17 of the blue connector.
•
Check continuity to ground of PIN 3 of the sensor.
•
Check continuity of the cable between PIN 2 of the sensor and PIN 24 of the ECU blue
connector.
•
Check PIN 24 of the blue connector.
•
If after all these checks the failure is not found, replace the sensor.
Speed sensor - over the maximum limit.
Error cause
•
Error signal if a speed above the default value set by the manufacturer for the running vehicle
is detected.
Troubleshooting
•
if over the maximum limit: replace the sensor.
GRISO 8V - 1200 Electrical system
ELE SYS - 57
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten