Specifications

Engine temperature sensor
Function
tells the engine temperature to the control unit so
as to optimise carburetion and idle control
Operation / Operating principle
NTC type sensor (resistance sensor, inversely
variable with temperature)
Level in wiring diagram:Temperature sensors
Location:
•
Sensor: on the right cylinder, inside the
"V"
•
Connector: on the sensor
Electrical characteristics:
ENGINE TEMPERATURE SENSOR RESISTANCE
Specification
Desc./Quantity
1 Resistance at -40 °C (-104 °F) 100.950 kOhm
2 Resistance at -30 °C (-22 °F) 53.100 kOhm
3 Resistance at -20 °C (-4 °F) 29.120 kOhm
4 Resistance at -10 °C (14 °F) 16.600 kOhm
5 Resistance at 0 °C (32 °F) 9.750 kOhm
6 Resistance at +10 °C (50 °F) 5.970 kOhm
7 Resistance at +20 °C (68 °F) 3.750 kOhm
8 Resistance at +30 °C (86 °F) 2.420 kOhm
9 Resistance at +40 °C (104 °F) 1.600 kOhm
10 Resistance at +50 °C (122 °F) 1.080 kOhm
11 Resistance at +60 °C (140 °F) 0.750 kOhm
12 Resistance at +70 °C (158 °F) 0.530 kOhm
13 Resistance at +80 °C (176 °F) 0.380 kOhm
14 Resistance at +90 °C (194 °F) 0.280 kOhm
15 Resistance at +100 °C (212 °F) 0.204 kOhm
16 Resistance at +110 °C (230 °F) 0.153 kOhm
17 Resistance at +120 °C (257 °F) 0.102 kOhm
Pin-out:
•
PIN 1: Ground connection
•
PIN 2: 0-5 V signal
THE CONNECTION DIAGRAMS ARE IN THE ELECTRICAL SYSTEM SECTIONS; PAY ATTENTION
TO THESE DIAGRAMS AS THEY SHOW THE CONNECTOR/COMPONENT AS VIEWED FROM
THE CABLE HARNESS SIDE, THAT IS LOOKING AT THE CABLES WHEN GOING OUT OF THE
"MAIN" CABLE HARNESS AND INTO THE CONNECTOR/COMPONENT.
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL CON-
CEPTS OF ELECTRICAL TROUBLESHOOTING FOUND AT THE BEGINNING OF THE CHECKS
AND CONTROLS SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
AXONE: FUEL INJECTION SYSTEM
AXONE: PARAMETERS
Engine temperature
GRISO 8V - 1200 Electrical system
ELE SYS - 61
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten