Specifications

•
An oil sensor failure is signalled when, with engine off, it is detected that the sensor circuit
is open. The test is performed only once when the key is set to ON. This error is signalled
by the bulb icon and the general warning light turns on as well.
Troubleshooting
•
Check the sensor connector and the instrument panel connector (PIN 17): If not OK, restore.
If OK, check the continuity of the purple cable between the sensor connector and the in-
strument panel connector PIN 17: if not OK, restore the cable harness; if OK, replace the
sensor.
Oil pressure failure DSB 08
Error cause
•
An oil sensor failure is signalled when, with engine running, it is detected that the sensor
circuit is closed. This error is signalled by the bulb icon and the general warning light turns
on as well.
Troubleshooting
•
Detach the sensor connector and check the purple cable is ground insulated: if there is
continuity to ground, restore the cable harness; if it is ground insulated, replace the switch.
It this error persists, use a pressure gauge to check the pressure of the oil in the engine
circuit
Neutral sensor
Function
it tells the gear position to the control unit: in neutral or in gear.
Operation / Operating principle
for gear in neutral, the circuit is closed to ground connection: then, via CAN, the control unit sends the
signal to the instrument panel which turns on the neutral speed warning light.
Level in wiring diagram:start-up enabling switches
Location:
•
Sensor: rear / upper side of the gearbox
•
Connector: on the sensor
Electrical characteristics:
•
Gear in neutral: closed circuit (0 V on wire from control unit to sensor / switch in continuity).
•
Gearshift engaged: open circuit (12 V on wire from control unit to sensor / open switch,
infinite resistance)
Pin-out:
1. Voltage 12V
AXONE: STATUSES
GRISO 8V - 1200 Electrical system
ELE SYS - 71
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten