Specifications

Example value:Yes/No
The statuses regularly viewed are YES / NO
DIAGNOSIS
Troubleshooting:
•
Indication on Axone always NO: check the correct position of the cable terminals on the
sensor and the correct connection of the cables on the terminals. If they are not correct,
restore the cable harness; if correct, disconnect the two terminals from the sensor and check
continuity to ground of PIN 2 (cable harness side): if there is no continuity, restore the cable
harness; if there is, replace the sensor. Check continuity of the brown/purple cable between
PIN 1 of the sensor and PIN 33 of the BLUE connector, cable harness side: if there is no
continuity, restore the cable harness; if there is, replace the sensor. With the key set to ON,
check that 12 Volt is fed to PIN 33 of the BLUE connector
•
Indication on Axone always YES: disconnect the terminals from the sensor and check if
there is continuity between the two PINS, with clutch released: if there is continuity, replace
the sensor. If the circuit is open, it means that the brown/purple cable from PIN 1 of the
sensor to PIN 33 of the BLUE connector is shorted to ground: restore the cable harness
Side stand sensor
Function
It tells the side stand position to the control unit.
Operation / Operating principle
If the gear is engaged and the side stand is unfolded, and therefore the circuit is open, the control unit
does not enable vehicle start-up or shuts off the engine if it is rotating.
Level in wiring diagram:start-up enabling switches
Location:
•
Sensor: on side stand supporting plate
•
Connector: left side, under the fuel tank
Electrical characteristics:
•
Side Stand Up: closed circuit (continuity)
•
Side Stand Down: open circuit (infinite resistance)
Pin-out:
1. Ground connection
2. Voltage 12 V (brown, sensor side)
AXONE: STATUSES
Side stand
Example value:retracted / extended
DIAGNOSIS
GRISO 8V - 1200 Electrical system
ELE SYS - 73
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten