Specifications

•
Indication on Axone always EXTENDED: check the side stand sensor connector and the
ECU connector: if they are not OK, restore; if OK, disconnect both terminals from the sensor
and check continuity to ground of PIN 1 (blue/green, cable harness side): if there is not
continuity, restore the cable harness; if there is, check continuity of the green/brown cable:
if it is not OK, restore; if OK, replace the sensor.
•
Indication on Axone always RETRACTED: disconnect the terminals from the sensor and
check if there is continuity between the two PINS, with stand down: if there is continuity,
replace the sensor; if the circuit is open, it means that the brown/green cable (cable harness
side) from PIN 2 of the sensor to PIN 38 of the BLUE connector is shorted to ground: restore
the cable harness
Bank angle sensor
Function
it tells the vehicle position to the control unit.
Operation / Operating principle
When the sensor is inverted, the circuit is closed
to ground: when the Marelli control unit detects this
earthing, it disables the fuel pump circuit and the
engine start-up circuit via the injection relay.
Level in wiring diagram:Start-up enabling
switches.
Location:
•
Sensor: close to the headstock
•
Connector: near the sensor
Electrical characteristics:
•
Sensor in vertical position: open circuit
(resistance: 62 kOhm)
•
Sensor inverted: closed circuit (resist-
ance below 0.5 kOhm)
Pin-out:
1. Voltage 12V
2. Ground connection
AXONE: STATUSES
Fall sensor
Example value: Normal / Tip over
DIAGNOSIS
Electrical system GRISO 8V - 1200
ELE SYS - 74
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten