User Manual

ManualsBrandsMotoMaster Eliminator ManualsAutomotiveMotoMaster Eliminator Precision Series 1.5A Battery Charger & Maintainer

C. Charging Modes

CONTROLS AND INDICATORS

A. Charge Status Indicator

B. Fault/Error Indicator

This battery charger has an easy-to-follow 4-LED charge status indicator: 25%, 50%,75%,100%. This

indicator provides an estimate of the battery’s state of charge as charging progresses. During charging, the

corresponding state of charge LED will be flashing. When the 100% LED lights solid (i.e., stops flashing), the

battery is fully charged and the charger has entered the Maintain stage (see Understanding the Multi-stage

Charging Process).

The charger will continuously monitor charge progress and collect feedback from the battery during

charging. In the event an abnormal condition is detected, charging will stop and the will illuminate to

indicate one of three possible error conditions:

headline bars

continuation tabs

headline bars

continuation tabs

notes

warnings

headline bars

continuation tabs

notes

warnings

headline bars

Model no. 011-1967-8 Questions? Contact us 1-888-942-6686

CONTROLS AND INDICATORS

12 V NORMAL

(14.4 V)

12 V COLD / AGM

(14.8 V)

12 V

RECONDITIONING

(15.8 V)

6 V NORM

(7.2 V)

MODE EXPLANATION

Battery Capacity Range

Charging Maintenance

For charging small to medium 12 V wet cell lead-acid

batteries.

5 to 40

Amp-hour

5 to 40

Amp-hour

5 to 40

Amp-hour

5 to 40

Amp-hour

5 to 200

Amp-hour

5 to 200

Amp-hour

Not applicable

5 to 200

Amp-hour

For charging small to medium 12 V wet cell lead-acid

batteries in cold temperatures (below 5 ) and for

many AGM batteries.

For charging small to medium 6 V wet cell lead-acid

batteries.

For reconditioning 12 V lead-acid batteries suffering

from capacity loss due to sulphation or stratification.

USE WITH CAUTION—see instructions and precau-

tions under Using Reconditioning Mode.

There are 4 charging modes to choose from. Pressing the MODE button repeatedly to cycle through each of

the three regular modes. To select the special mode (RECONDITIONING), hold the MODE button for 3

seconds. Charging will automatically begin about 5 seconds after the charge mode has been selected.

NOTE: The battery charger will retain the last selected mode in memory. In the event AC power is disrupted

(e.g., power failure), the charger will re-start in the last selected mode once power is restored.

Amber (solid)

Power ON but no battery detected: Check to ensure that clamp connections to the battery posts are

clean and solid. If connections are good, the battery is severely discharged (<1.5 V) and may be

unsafe to charge. The battery should be tested or replaced.

Red (flashing)

Fault /error: Charging aborted due to some abnormality detected such as a defective battery or

short circuit (see Troubleshooting).

Reverse polarity: Reverse clamp connections.

Red (solid)

Small (10–25 Ah)

Compact car, mid-size sedan, compact SUV, riding mower, UTV

Full-size car, large SUV, truck, boat, RV, farm tractor

Large marine, tractor trailer, bus, multiple batteries connected in a bank

For reference only. Please check the specifications listed on your battery or consult with the battery

manufacturer.

Motorcycle, scooter, ATV, personal watercraft, snowmobile

Medium (30–50 Ah)

Large (60–100 Ah)

Extra large ( 100 Ah+)

Examples of Battery Sizes in Common Applications

notes

warnings

CONTROLS AND INDICATORS

For best results, check the charging recommendations on your battery or consult with the battery manufacturer.