Network Router User Manual

3 1/2 x 1/4 inch bolt

1/4 Flat Washer

1/4 Lock Washer

1/4 Hex Nut

Note: All Hardware is Stainless Steel

Figure 2-5. C-Clamp Bracket Assembly

3. Position the bracket in the desired location and securely tighten the two bracket bolts.

4. If required, loosen the Pivot Bolt and the Angle Locking Bolt (

Figure 2-6) so that the

antenna connector is positioned vertically.

5. Ensure that the antenna connector is still vertical and tighten the Pivot Bolt using a 7/16-

inch open-end wrench or socket wrench.

6. Tighten the Angle Locking Bolt using a #1 Phillips screwdriver.