User Guide Modem 3460

3460 Fast’R
B-3
P Select Pulse Dialing
Has same effect as AT
*
PT1
Q Display Result Code
Q0 =Enable. Result codes are displayed on the computer.
Q1 =Disable
Q2 =Originate. Display result codes only when modem is in
Originate mode.
S Store Value in S-Register
Sx=n Store value n in S-Register x
T Select Tone Dialing
Has same effect as AT
*
PT0
V Result Code Format
V0 Numeric Code
V1 Text Description
X Control Call-Progress Reporting
Determines whether the modem waits for call progress
signals or blind dials when establishing calls.
X0 =Modem uses only NO CARRIER and CONNECT
result codes.
X1 =Modem uses only NO CARRIER, CONNECT, and
CONNECT <Rate> result codes.
X2 =Modem waits for dial tone and uses only NO
CARRIER, CONNECT, CONNECT <Rate> and NO
DIALTONE result codes.
X3 =Modem detects busy signal and uses only NO
CARRIER, CONNECT, CONNECT <Rate>, and
BUSY result codes.
X4 =Modem waits for dial tone and detects busy signal.
Uses only NO CARRIER, CONNECT, CONNECT
<Rate>, BUSY, and NO DIAL TONE result codes.
AT Command Set (continued)
Command Option Description
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.