User Guide Modem 3460

3460 Fast’R

3-8

AT Commands for Modem Tasks

AT Action Commands

AT commands for performing basic functions are as follows.

Sync Idle AT

V11=Char

V.25 Response AT

VR1=V.25bis

Table 3-2. AT Commands to Manage Option Sets

To...

Enter This

Command:

Load Option Set 1 into modem memory ATZ0 or ATZ1

Load Option Set 2 into modem memory ATZ 2

Specify that the modem loads Option Set 1 into

memory at subsequent power-ups

AT& Y1

Specify that the modem loads Option Set 2 into

memory at subsequent power-ups

AT& Y2

Specify that the modem loads the last-saved option

set (AT&W) at subsequent power-ups

AT& Y0

Save the active configuration into Option Set 1 AT&W0 or AT&W1

Save the active configuration into Option Set 2 AT& W2

Table 3-3. AT “Action” Commands

Command & Option Description

+++ Enter Local Escape Mode

##### Enter Remote Escape Mode

A/ Re-Execute Last Command

*The contents of the following S-registers are not automatically saved when

power is removed: 0, 1, 2, 3, 4, 5, 41, 42. To retain values, save them to an

option set. (S-Registers are storage areas for some parameter options.)

Table 3-1. Option-Set Default Options

(continued)

Command

Pre-Configured Default Option

Option Set 1

(Asynchronous)

Option Set 2

(Synchronous)

Parameters and options shown shaded gray vary by country. For details, refer

to Appendix B of the 3460 Fast’R Reference Guide.

Parameter option does not affect normal operation.