User Guide Modem 3460

3460 Fast’R
3-11
ATX4=Modem waits for dial
tone and detects busy signal.
Uses only NO CARRIER,
CONNECT, CONNECT
<Rate>, BUSY, and NO DIAL
TONE result codes.
Terminal Options
Terminal Inactivity
Disconnect
Country-specific S30=n; n=0-255 sec.
DCD Loss Disconnect Country-specific S10=n; n=1-255 sec.
Telco or Telco Jack Options
DL TX Level (dB) Country-specific AT
*
DX0 - AT
*
DX30
LL Tx Level (dB) Country-specific AT
*
LX0 - AT
*
LX30
Speaker Control ATM1=Dialing ATM0=Always Off
ATM2=Always On
ATM3=On During
Training
Speaker Volume ATL2=Medium ATL0 or ATL1=Soft
ATL 3=Lo ud
Dial Line Filter AT
*LF2=Short AT*LF0=Long
AT
*LF1=Medium
AT*LF2=Short
AT*LF3=Not
recommended
Dialing Options
Pause Delay Country-specific ATS 8=n; n=value
Dial Wait Country-specific AT
*
DD0 - AT
*
DD9
Dial Mode Country-specific AT
*
PT0 - AT
*
PT2
Call Timeout Country-specific AT
*
TT0 - AT
*
TT5
Blind Dial Country-specific ATS6
Pulse Cycle Country-specific AT&P0 - AT&P2
Tone Length Country-specific ATS11
Auto Redial Country-specific AT
*
DR0 - AT
*
DR15
Table 3-5. Site-Specific Parameters (continued)
Parameter Default Option Available Option