Operation Manual

42 Registration
take about 10 seconds to complete the registration. The
handset will display
HANDSET X REGISTERED , with X
denotes the handset number (1-6). There will be a beep
sound if the registration is successful.
NOTES
1. If the registration is not successful, the display will show
NOT REGISTERED . To reset the handset, remove the
handset from the telephone base and place it back in.
Try the registration process again.
2. You cannot register a handset if any other system
handset is in use.
7.2 De-register all handsets
You may need to de-register your handsets if:
You have five registered handsets and need to replace a unit.
OR
You wish to change the designated handset number of your
registered handsets.
You must first de-register ALL the handsets, and then re-
register each handset you wish to use.
Please read carefully through all the instructions on this
page before beginning the de-registration process.
1. Press and hold a on the telephone base for about 10
seconds (until the IN USE light turns on and starts to
flash quickly), then release the
a button.
2. Immediately press and release a again. You must
press
a while the IN USE light is still flashing. (The
light flashes for about seven seconds. If the light stops
flashing, pick up the handset and place it back into the
telephone base, then start again with step one above.)
3. The handset(s) will show SEARCHING FOR BASE and it will
take about 10 seconds to complete the de-registration
process. ALL handsets will show
NOT REGISTERED if de-
registration was successful.
4. To re-register the handset(s) to the telephone base,
follow the registration instructions as section above.
NOTES
1. If the de-registration process was not successful, you
may need to reset the system and try again. To reset:
pick up the handset and press the
< button, then press