Operation Manual

26
Base settings
6.4 Dial mode
Your C12 is set to tone dialling. You should only need to change this if
connected to an older type of switchboard / PBX which requires
pulse dialling.
1. Press
, scroll to SETUP and press .
2. Scroll
to DIAL MODE and press .
3. Press
or to select TONE DIAL or PULSE DIAL and press to conrm.
6.5 Recall mode
Depending on your country and network operator, your C12 has the recall
time set as 600 ms (TIMED BR,2). It is unlikely that you need to change this
setting unless advised to do so.
1. Press
, scroll to SETUP and press .
2. Scroll
to RECALL and press .
3. Press
or to select TIMED BR,1 (short ash time) or TIMED BR,2 (long ash
time) and press
to conrm.
6.6 Restore default settings
You can restore your C12 to its default (original) settings.
All the handsets that are registered to the base will be retained.
IMPORTANT
Resetting your phone to its default settings will delete all entries in the
Phonebook and Calls list. All handset and base settings will also be reset.
1. Press
, scroll to SETUP and press .
2. Scroll
to DEFAULT and press .
3. Enter the 4 digit PIN code (default = 0000) and press
. The display
shows
CONFIRM ? .
4. Press
to conrm or to return to the previous menu. Your C12
will restart automatically.
6.7 Emergency default
If you have lost your PIN code, you can still restore your C12 to its
default settings.
1. Remove the batteries from the handset.
2. Press and hold
while replacing the batteries. The display
shows
DEFAULT.
3. Press to conrm. Your C12 will restart automatically.