Network Router User Manual

Release 11.0 Release Notes and User Guide Supplement
Issue 1, March 2011 Page 47
FCC ID
Industry
Canada
Cert
Number
Frequencies
Module
Families
Antenna
Maximum
Tx Output
Power
4940 AP
18 dBi connectorized
PCTEL Model AP
85010066001 antenna
(60° x 5° -3 dB beam
width) with 1 dB cable
loss
18 dBm
ABZ89FT7631
109W-4940
10 MHz channels,
centered on 4945-4985
in 5 MHz increments
(within the 4940-4990
MHz public safety
licensed band)
4940 SM
4940 BH
17 dBi integrated
antenna (15.5° x 17.5°
(el x az) -3 dB beam
width)
18 dBm
Note 1: To ensure regulatory compliance, including DFS compliance, the professional installer is responsible
for:
◦ setting the Region Code on the Configuration => General page to the correct region
◦ setting the Transmitter Output Power on the Confiiguration => Radio page no higher than listed for a given
configuration
◦ setting the External Gain on the Configuration => Radio page, if displayed, to the gain of any external
device (such as a reflector or lens)
11.2.2 Industry Canada (IC) Notification
For 900MHz, 2.4-GHz, 5.2-GHz. 5.4-GHz, 5.7-GHz and 5.8-GHz devices:
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Users should be cautioned to take note that in Canada high power radars are allocated as primary users
(meaning they have priority) of 5250 – 5350 MHz and 5650 – 5850 MHz and these radars could cause
interference and/or damage to license-exempt local area networks (LELAN).
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
RSS-210 of Industry Canada. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio-frequency
energy and, if not installed and used in accordance with these instructions, may cause harmful interference
to radio communications. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and off, the user is encouraged to correct
the interference by one or more of the following measures:
 Increase the separation between the affected equipment and the unit;
 Connect the affected equipment to a power outlet on a different circuit from that which
the receiver is connected to;
 Consult the dealer and/or experienced radio/TV technician for help.
To reduce potential radio interference to other users, the antenna type and its gain should be chosen so its
Equivalent Isotropic Radiated Power (EIRP) is not more than that permitted for successful communication.
Industry Canada Certification Numbers and the specific configurations covered are listed in Table 15.
This device has been designed to operate with the antennas listed in Table 15 and having a maximum gain
as shown in Table 15. Antennas not included or having a gain greater than as shown in Table 15 are strictly
prohibited from use with this device. Required antenna impedance is 50 ohms.