Stereo System User Manual

4-6 DSP56012 User’s Manual MOTOROLA
Parallel Host Interface
Port B Configuration
4.2.1 Port B Control (PBC) Register
The Port B Control (PBC) register determines which set of functions are used with the
external multiplexed pins. As shown in Figure 4-2 on page 4-4, there are three valid
combinations:
• Parallel I/O (default)
• Host Interface
• Host Interface (with HACK as GPIO)
The default setting (BC1:BC0 = 00) defines the pins as GPIO signals. The other
settings must be programmed by writing to the PBC register. Writing a $1 to the
register defines the pins as the HI port. Writing a $2 to the PBC register defines the
pins as an HI port without a HACK
signal; the pin used by HACK in the HI is
defined as a GPIO pin (PB14).
Figure 4-4 Port B I/O Pin Control Logic
Port Control
Register Bit
Data Direction
Register Bit
Pin Function
00
Port B Input Pin
01
Port B Output Pin
1X
HI Function
Port B
Registers
HI Input Data Bit
HI Data Direction Bit
HI Output Data Bit
Port B Input Data Bit
Pin
Port B Data (PBD)
Register Bit
Data Direction
Register (PBDDR) Bit
Port B Control
Register (PBC) Bit
(GPIO
Position)
(Input
Position)
Peripheral
Logic
AA0310.11