- motorola Installation and Operation Manual Portable Radio GP68

2 • Operating Modes
21
Example #3: If a subscriber primarily has only radio dispatch/fleet
requirements, both the Primary Code and the Second-
ary Codes may be assigned to group Paging Codes.
When programmed in this manner, the equipment will
respond to two groups (Group and Sub-Group). The
operator of this equipment can only receive Group or
Sub-Group calls. An individual user in the subscriber
group can make individual outgoing calls to the landline
(Primary Code is used).
Table 2-1 illustrates a possible programming/activation scenario. The first three
subscribers are individual subscribers using half duplex type equipment. These
paging codes will be programmed into only one piece of subscriber equipment in
the Primary Code position. The fourth and fifth entries are group subscribers. The
group paging code may be programmed into many pieces of subscriber equipment
as Primary Code or Secondary Code (Group/Sub-Group).
Table 2-2 depicts how four pieces of user equipment may be programmed
related to Table 2-1.
Subscriber Equipment #1 will operate as an individual user.
Subscriber Equipment #2 will operate as an individual and be
grouped with #4.
Subscriber Equipment #3 will operate as an individual, with
grouping to #4 but NOT grouped with
#2.
Subscriber Equipment #4 operates with two groups. Thereby
being associated with #2 and #3.
Subscriber Type Paging Code
ID Number
10000 half 4100
10001 half 4101
10003 half 4102
90000 group 4103
90001 group 4104
Table 2-1  ST-852M Programming