- motorola Installation and Operation Manual Portable Radio GP68

he ST-865M3 provides the installing technician a flexible programming

capability after the ST-865M3 has been installed in the radio. The ST-

865M3 is programmed by using the keypad on the front of the radio. No

special cables or other attachments are required. All programming information

is retained in a non volatile EEPROM.

To test the installation and programming of the ST-865M3, a functional ST-

852M with the system ID numbers and paging codes correctly programmed is

required. See the ST-852M SmarTrunk II Digital Trunking Controller manual

for details on adding subscriber ID numbers to the system.

4.1 Entering The Program Mode

To enter the programming mode, perform the following steps:

a. Turn the radio off.

b. Press and hold the # key on the front panel keypad.

c. Turn the radio on.

d. After the beep is heard, release the # key.

e. Enter the dealer programmed 5 digit access code, followed by the

# key. The default access code is 12345.

f. The ST-865M3 will respond with a high beep. If a low beep is

heard, the access code was incorrect. Turn the radio off and try

the procedure again.

4.2 Programming Feature Descriptions

The ST-865M3 programming features are described herein. A

programming worksheet is provided in Appendix A. This worksheet

should be copied and filled out for each subscriber and used as a

record of the programming for that particular subscriber.

4 • LOGIC BOARD PROGRAMMING